GENERAL INFORMATION
Montana Acrylic Marker are available in 5 different tips sizes: 0,7mm, 2mm, 15mm, 30mm and 50mm.
FEATURES
- Waterbased
- Weatherproof when dry
INSTRUCTIONS FOR USE
Shake the markers vigorously for 2-3 minutes before use...
APPLICATION INFORMATION
- Surfaces should be dry and clean of oil, dirt or rust
- Always perform a test on a non-visible area
PRODUCT INFORMATION
PRODUCT NAMES: Montana ACRYLIC Markers
HS CODE: 96082000
COUNTRY OF ORIGIN: Japan
TECHNICAL INFORMATION
CONTENT: See "INK FILLING VOLUMES" below.
LAQUER BASE: Water-based Acrylic
GLOSS LEVEL (60° angle according to DIN 67530): 5-10 GE matte
HEAT RESISTANCE: Up to 80°C (176°F)
COVERAGE: Good
OVERPAINTING: Can be overpainted with Nitro-Combi (NC) or Acrylic Lacquer after approx. one hour drying time
DRYING TIME AT 20°C (68°F) AND 50% RELATIVE HUMIDITY:
- Dust/Touch dry: approx. 4-5/10 min.
- Overpainting after 1h.
- Fully cured after 6h
Drying time depends on temperature, humidity and thickness of coating.
OPTIMAL PROCESSING CONDITIONS:
- Temperature 10° - 25°Celcius
- Surface temperature 5° - 40°Celcius
- Air humidity max. 60%
INK FILLING VOLUMES
| MARKER SIZE | STANDARD COLORS | METALLIC COLORS |
| 0,7mm | 5g | 3g |
| 2mm | 8g | 5g |
| 15mm | 45g | 30g |
| 30/50mm | 45g | 30g |
FREQUENTLY ASKED QUESTIONS
When should I use a primer?
The goal of priming is to create a neutral surface to provide the longest possible lifespan and the most aesthetic finish for further coatings. Montana-Cans Primers are for pre-treatment and preparation of surfaces and will offer the greatest adhesion and protection to apply further coatings onto.